April 2006CAUTIONThe restore function will overwrite the existing HMS 400databases and configuration files. It is recommended to rerunthe last PEP installed after system restoration.5. To start the restore process, click Restore Now.6. When the progress bar reaches the end, a Restore Completed dialogue box will appearindicating the completion of the restore process as well as the destination path of the restoreddata.7. If system was not configured to auto-backup, then it is recommended to install the latest PEPafter restore is completed. Refer to Chapter 6 of this document.8. Re-start the HMS 400 system, refer to Page 103 (Point 2) of the “HMS 400 Installation Guide(NN42350-301)”Backup and Restore LogsThe logs for the backup and restore transactions are located in C:\HM\BackupRestoring the System from Image DiskThis section describes the steps to restore the HMS 400 from an image CD in the event of harddisk failure.Procedures to restore from an Image Disk are as below:1. Remove the dongle from the USB port.2. Ensure that the Dialogic card(s) are in the server and the lines are connected to the breakoutbox.3. Place Recovery CD-1 into the CD-Rom drive.4. Exit HMS 400 system and reboot the server.5. The following screens reflect the recovery process from the Image Disk. Follow the stepsaccordingly for each screen.Select desired operation1. Recovery CD2. HMS 400 SSU3. ExitType 1Nortel Hospitality Messaging Server 400 -37-Maintenance Guide
