Nortel Meridian 1 Manual
Also see for Meridian Meridian 1: Installation guideImplementation guideScripting GuideConfiguration manualDescription
                                                                                        | |
Contents
|
Page 54 of 86 Operation procedures and tests553-2731-300 Standard 4.00 April 2000Keypad dialing from the ASIM data stationKeypad dialing is applicable to ASCII, asynchronous/synchronous start-stopcharacter mode, and interactive terminals equipped with an EIA RS-232-Cinterface.The ASIM and keypad dialing provide the following capabilities:• Call origination to local and remote hosts• Manual or Auto-answer• Ring Again• Autodial data calling to local hosts• Speed Call• Automatic set relocation• Asynchronous data baud rate of 110, 150, 300, 600, 1200, 2400, 4800,9600, and 19200 bps• Synchronous data baud rate of 1200, 2400, 3600, 4800, 7200, 9600,19200, 38400, 40800, 48000 and 56000 bps (ASIM only)• Two stop-bits for 110 baud and one bit for all other baud ratesMiscellaneous information• Ensure that the data terminal is on-line and both the terminal and theASIM are turned on.• Dial the call from the standard dial pad on the ASIM. The * and # areaccepted and treated as touch pad items.• For set relocation, the off-hook and on-hook are simulated as follows:— Off-hook: Press reserved key below Ring Again and then press *key.— On-hook: Press reserved key below Ring Again and then press #key.• Use RELEASE key if it is necessary to abandon a call during call setup. |
Related manuals for Nortel Meridian Meridian 1
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine