Chapter 4 Using VLAN Manager 89Using Optivity Switch Manager, Release 1.1.0.09 In the ProtocolId box, select the protocol.If you select UsrDefined, refer to “User-defined protocols in a protocol-basedVLAN” on page 89 for more information.10 Select the device to be configured on the VLAN by doing one of thefollowing:• Select from the device list.• Click On All Devices to select all devices in the list.11 Click Ok.12 In the Ports table, specify the port membership by clicking on one or all of thefollowing columns and specifying ports:• ActiveMember• PotentialMembers• StaticMembers• NotAllowedToJoin13 Do one of the following:• From the VLAN Manager menu bar, choose Apply Changes.• On the VLAN Manager toolbar, click Apply Changes.User-defined protocols in a protocol-based VLANYou can create a protocol-based VLAN with a user-defined protocol forintegration into existing networks where nonstandard protocols are used.In the UserDefinedPId text box, enter the PID of the protocol in the format 0x(protocol type in decimal value).• For a Passport 8600 switch and Passport 1000 Series switch, the 16-bit PIDassigned to a protocol-based VLAN specifies either an Ethertype, a DSAP/SSAP, or a SNAP PID, depending on whether the frame encapsulation isEthernet 2, 802.2, or LLC-SNAP, respectively.• For a Passport 8100 switch, the 16-bit PID assigned to a protocol-basedVLAN specifies only an Ethertype for Ethernet 2 frame encapsulation.
