Nortel Secure Router 4134 Installation Manual

Also see for Secure Router 4134: Installation Installation instructions Quick start Configuration Installation

Contents

Nortel Secure Router 4134 Installation Manual Manual pdf 40 page image

40 Prepare and install the Secure Router 4134 chassisTable 8Secure Router 4134 accessoriesAccessory Description VerifiedRack mounting bracket thatcontains two rack mountingbrackets and 20 Phillips-headscrews.Supports the chassis in an equipment rack.The screws for the mounting brackets are 8-32 x1 /4 (12).The two types of screws for the rack mount areas follows:For telecom racks—12-24 x 5/8 Phillips (4)For cabinets—10-32 x 1 /2 Phillips (4)Console cable Connects a management console to the chassis.Female DB-9 to RJ-45connectorUse, if necessary, to connect the console cableto a terminal or PC.Power cord Country-specific power cord provided for ACinput. One power cord is provided for eachpower supply module you ordered.The power cord is a no-charge item that issupplied with the chassis; however it mustappear as a separate item on your order.Terminal (ground) lug and twoscrewsConnects the ground wire to the front panel ofthe chassis.Screws:8-32 x .187 inch (in.) pan head screws withexternal tooth washer (2)Software and documentationCDContains the Secure Router 4134 softwareimage file, as well as the installation andconfiguration manuals.Installing the mounting brackets on the Secure Router 4134You must install the mounting brackets on the Secure Router 4134 beforeyou install the chassis in an equipment rack. You can mount the SecureRouter 4134 with either the front panel or the back panel facing theoperator. The following table shows the six possible mounting positions.Average time to install mounting brackets: 2 minutes.Nortel Secure Router 4134Installation — ChassisNN47263-300 03.01 7 September 2009Copyright © 2007-2009 Nortel Networks. All Rights Reserved.