Nortel Versalar 5399 Quick Start Manual

Also see for 8000 Series: Reference guide Installing and maintaining Installing

Contents

Nortel Versalar 5399 Quick Start Manual Manual pdf 26 page image

Quick-Start Guide for Nortel Networks 5399 and 8000 Access Switches14 300855-C Rev. 006. Set up the RAC so that addresses are on the DS0s.admin: wan 1admin: set wan=1 ds0=all remote_address 1admin: reset wanTask 9: Reboot the RACAfter making all the configuration changes, you must reboot the RAC for thechanges to take effect. After you reboot the RAC:1. Connect the cables to the WAN interface ports on the front (Model 5399)or back (Model 8000) of the RAC.2. Test the RAC by dialing into it.Task 10: Customizing the RACAfter installing and booting the RAC, you can customize RAC parameters (forexample security or port parameters) using one of the following tools:• CLI interface (see Managing Nortel Networks 5399 and 8000 Access SwitchesUsing Command Line Interfaces)• Config Utility (see Installing and Administering the Config Utility and theConfig Utility online Help system)RoadmapThe roadmap provides a series of tasks that you must perform in sequential orderto install, configure, and boot a RAC. Refer to the specified documentation fordetailed instructions. The roadmap can be divided into two distinct sections:installation and configuration, and customization.Note: IP addresses are incremented from the starting IP address using anincrement of 1. Addresses will be applied on all DS0s and will be used atrandom as the DS0s are used at random. Addresses are assigned to users oncethey dial in.