Nortel i2021 Series User Manual
                                                                             | |
Contents
| 
i2021 ISDN Teleset13Choosing Search returns the next screen, assuming the Directory isempty.Connecting THE i2021- AUTO-INSTALL1. Assemble the i20212. Verify the PS1/PS2 switch located on the bottom of the Teleset isset correctly. See page 6 for further information on setting thePS1/PS2 switch.3. Verify the Terminating Resistor (TR) switch is set correctly. Seepage 6 for further information on setting the TR switch.4. Connect one end of the eight-pin mounting cord to the ISDN Line-In jack on the bottom of the Teleset. Connect the other end of thecord to the S/T jack on your NT1 or ISDN telephone wall jack.5. Remove the protective film on the display.6. Label and install the designation cardAUTO-INSTALLThe i2021 is equipped with an Auto-Install feature. The purpose of Auto-INSTALL is to ensure a complete and painless installation. In this mode,the i2021 will first detect the type of switch the i2021 is connected to, andthen will attempt to Auto-SPID. The switch will automatically download thefeatures. The i2021 will then step through each of its programmingchoices and give you the opportunity to make a selection. After you havemade the selection press the “MORE” key to continue.NOTE: Make sure the logo plate is installedNOTE: You may abort the Auto-Install by pressing the Menukey at any time |
Related manuals for Nortel i2021 Series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine