AFP-3030 Installation Manual — P/N DOC-01-031:F 19/11/2018 7Section 2: System Overview2.1 System Description2.1.1 Standard Features• Connections to easily mount from one to ten Signalling Line Circuit (SLC) loops• Network operation• Uses Notifier’s VIEW® early warning fire detection and the FlashScan® or CLIP families of detectors and modules• Alarm, Fault, and Supervisory relays• Support for 32 annunciator addresses with either 64 or 96 points each (depending on the capability of the annunciator)• Supports Open (Style 4) and Closed (Style 6/7) SLC loops• Logic Equations• Multi-line display• Ability to activate local sounder or relay bases in alarm or pre-alarm• Supervisory duct and smoke detectors• Supports Intelligent Sensing algorithms• EIA-485 connections for wiring ACS annunciators (including LDM custom graphic annunciators), TM-4 transmitter• EIA-232 connection for printer• Autoprogram feature for faster programming of new devices• Easy connection to VeriFire® Tools programming utility• The basic system power supply charges sealed lead-acid batteries ranging in capacity from 11 to 85 amp hours, and provides up to5 amps of power for use by the CPU.• Easy connection to auxiliary power supplies and battery chargers for custom design of very large systems.• Ground fault detection• Mass Notification System compatible12.1.2 OptionsRefer to Section 2.3 “System Components” for descriptions of the various optional modules.• Rubberized keypad with a standard “QWERTY” keyboard layout, a 640-character LCD display, indicator LEDs, and switches.• Separately ordered Loop Control Modules and Loop Expander Modules provide up to ten SLC loops.• Optional equipment includes: ACS devices, ACM-8RA remote relay module to provide additional relay points, and audio/voicecomponents.2.1.3 System LimitationsSystem expansion must take into consideration the following:1. The physical limitations of the cabinet configuration.2. The electrical limitations of the system power supply.3. The capacity of the secondary power source (standby batteries).1. Control Active LED is not supported.