Notifier NFS-3030/E Installation Manual

Contents

Notifier NFS-3030/E Installation Manual Manual pdf 39 page image

Connecting Power Sources and Outputs Section 3 InstallationNFS-3030 Installation PN 51330:C 10/28/2003 393.15 Connecting Power Sources and OutputsOverviewComplete all mounting procedures and check all wiring before applying power. Electrical connectionsinclude the following:• Primary power source. +24VDC, delivered through AMPS-24/AMPS-24E main power supply.If AMPS-24/E is mounted in a separate cabinet, power-supply wiring must be in conduit (forcabinet placement information see Section 3.4 “Laying Out Equipment in Cabinet and Chassis”and the AMPS-24/E manual.• Secondary power source. +24 VDC from batteries, installed in the control panel (or in anoptional battery cabinet). Secondary (battery) power is required to support the system duringloss of primary power.• External power sources. +24VDC auxiliary power supplies that are UL/ULC-listed for fireprotective service.• Accessory power for peripheral devices. TB6 on the CPU draws power from primary,secondary and external sources to supply a maximum of 1.0 amp of +24 VDC power to deviceswithin the same enclosure as the CPU. If those devices have outputs, the outputs must be power-limited.Note: The CPU ships with an insulator to prevents its lithium battery from discharging. To preserve thebattery, this insulator should be left in place as long as possible before applying AC power. Someinstallers may find it convenient to remove the insulator before mounting all equipment.Note: If using multiple power supplies with one set of batteries, refer to main power supply manual forconnection requirements.Connecting the Power SupplyConnect J13 Power on the CPU to TB2 on AMPS-24/E with Cable 75591 (see Figure 28). This cable is20 feet long, and must run in conduit between the backbox containing the fire alarm control panel andthe backbox containing the AMPS-24/E. See AMPS-24/E manual for full details and installationprecautions.In order to conserve batteries, connect AC power and check it before connecting batteries. Follow theprocedures specified in the power supply manual.!WARNING: Remove all power sources to equipment while connecting electrical components.Leave the external, main power breaker OFF until installation of the entire system is complete.!WARNING: Several sources of power can be connected to the control panel. Before servicing thecontrol panel, disconnect all sources of input power including the battery. While energized, thecontrol panel and associated equipment can be damaged by removing and/or inserting cards,modules, or interconnecting cables.!bWARNING: Auxiliary power supply connections to ICM-4RK/ICE-4 must come from a powersupply whose battery terminals are tied back to those on the main power supply. Failure to do sowill cause panel circuit trouble at the control panel and possible equipment damage.