Notifier NFS-3030/E Installation Manual

Contents

Notifier NFS-3030/E Installation Manual Manual pdf 57 page image

Fire/Security Applications Section 4 ApplicationsNFS-3030 Installation PN 51330:C 10/28/2003 574.6 Releasing ApplicationsOverviewThis control panel can be used for non-hazardous agent release or preaction/deluge control applicationsvia the SLC loop. In a properly configured system with compatible, listed actuating and initiatingdevices, this control panel complies with the following NFPA standards for installation in accordancewith the acceptable standard:Table 7 NFPA Standards for Releasing ApplicationsProgrammingThe control panel supports up to ten releasing software zones. You can map these zones to activatecontrol modules. Program the FCM-1 module for the appropriate Type Code according to the chartbelow:For more information, refer to the NFS-3030 Programming Manual.WiringMake sure to keep total system current within the limits of the power supply. You can power the modulefrom the power supply of the control panel or any UL-listed 24 VDC regulated power-limited powersupply for Fire Protective Signaling. For more information, refer to the Device CompatibilityDocument.References to wiring diagrams for releasing applications:Standard CoversNFPA 13 Sprinkler SystemsNFPA 15 Water Spray SystemsNFPA 16 Foam-Water Deluge and Foam-water SpraySystemsNFPA 17 Dry Chemical Extinguishing SystemsNFPA 17A Wet Chemical Extinguishing SystemsNFPA 2001 Clean Agent Fire Extinguishing SystemsTable 8 Type Codes for Releasing ApplicationsType Code: RELEASE CKT• For use in UL applications• Do not use REL-47K• Cannot use power-limited wiring• Supervised for open circuit only• Supervised for power lossType Code: REL CKT ULC• For use in UL or ULC applications• Requires REL-47K at solenoid• Power-limited wiring• Supervised for open circuit and shorts• Supervised for power lossTo connect Refer toA releasing device to a FCM-1 Module. Section 4.7.An NBG-12LRA Agent Release-Abort Station. Section 4.7.1.