184 OES 2 SP2: Installation Guidenovdocx (en) 7 January 201010.4.4 Completing the OES 2 SP2 VM Guest Installation1 Follow the on-screen prompts, using the information contained in the following sections:1a Section 3.3.4, “Setting Up the Clock and Time Zone,” on page 48.1b Section 3.3.5, “Specifying the Installation Settings for the SLES Base and OESInstallation,” on page 48.1c Section 3.3.6, “Specifying Configuration Information,” on page 54.During the configuration portion of the installation, you might see additional promptsconcerning hardware detection of the network cards, DSL, PPPoE DSL, ISDN cards, andmodems.When you specify the time source during the eDirectory configuration, use the same timesource as the eDirectory tree you are installing the server into.After the installation, enable the virtual machine’s Independent Wall Clock setting andreboot the virtual machine so it can synchronize its time correctly. For more informationon this configuration issue, “Virtual Machine Clock Settings (http://www.novell.com/documentation/sles10/book_virtualization_xen/data/sec_guest_suse.html#sec_xen_time)”in the Virtualization with Xen (http://www.novell.com/documentation/sles10/book_virtualization_xen/data/book_virtualization_xen.html) guide.1d Section 3.4, “Finishing the Installation,” on page 71.During the hardware configuration, graphics and sound cards are not recognized wheninstalling OES 2 SP2 as a VM guest.2 Complete the server setup by following the procedures in “Chapter 6, “Completing OESInstallation or Upgrade Tasks,” on page 143.”10.5 Upgrading an OES 2 VM Guest to OES 2SP2 Section 10.5.1, “Upgrading an OES 2 VM Guest by Using the Update Channel,” on page 184 Section 10.5.2, “Performing an Offline Upgrade,” on page 18410.5.1 Upgrading an OES 2 VM Guest by Using the UpdateChannelPatching or updating an OES 2 SP2 VM guest is essentially the same as updating an OES 2 SP2physical server. For instructions on updating a physical OES 2 SP2 server, see Section 5.4.5, “Usingthe Patch Channel to Upgrade (Online),” on page 119.10.5.2 Performing an Offline UpgradeNOTE: If you are upgrading by using a network location or an ISO file, the process is quite lengthy.Physical media upgrades are not supported.If your guest VMs have access to a patch channel, we recommend that you upgrade by using thepatch channel. See Section 5.4.5, “Using the Patch Channel to Upgrade (Online),” on page 119.
