Installing OES 2 SP2 71novdocx (en) 7 January 2010Configuring Novell Open Enterprise Server Services1 After you complete the LDAP configuration or the eDirectory configuration, the Novell OpenEnterprise Server Configuration summary page is displayed, showing all the OES componentsyou installed and their configuration settings. Review the setting for each component and clickthe component heading to change any settings.When you specify the configuration information for OES services, see the information in“Guidelines for Configuring OES 2 SP2 Components” on page 73.2 When you are satisfied with the settings for each component, click Next.3 When you confirm the OES component configurations, you might receive the following error:The proposal contains an error that must be resolved before continuing.If this error is displayed, check the summary list of configured products for a messageimmediately below each product heading. The list indicates the product or service needs to beconfigured. If you are running the YaST graphical interface, the text appears red. If you areinstalling through the YaST text-based interface, it is not red.For example, if you have selected Linux User Management in connection with other OESproducts or services, you might see a message similar to the following:Linux User Management needs to be configured before you can continue ordisable the configuration.If you see a message like this, do the following:3a On the summary page, click the heading for the component.3b Supply the missing information in each configuration page.When you specify the configuration information for OES services, see the information in“Guidelines for Configuring OES 2 SP2 Components” on page 73.When you have finished the configuration of that component, you are returned to theNovell Open Enterprise Server Configuration summary page.3c If you want to skip the configuration of a specific component and configure it later, clickEnabled in the Configuration is enabled status to change the status to Configuration isdisabled.If you change the status to Configuration is disabled, you will configure the OEScomponents after the installation is complete. See “Installing or Configuring OES 2 SP2on an Existing Server” on page 103.4 After resolving all product configuration problems, click Next to proceed with theconfiguration of all components.5 When the configuration has completed, continue with Section 3.4, “Finishing the Installation,”on page 71.3.4 Finishing the InstallationThe installation concludes with the following steps:1. User Authentication Method2. Clean Up3. Release Notes4. Hardware Configuration
