Installing OES 2 SP2 81novdocx (en) 7 January 2010For additional instructions, see the OES 2 SP2: Novell Cluster Services 1.8.7 for LinuxAdministration Guide.3.6.7 Novell DHCP ServicesTable 3-11 Novell DHCP Services Parameters and Values Cluster IP Address: If you are creating a new cluster, specify a unique IP address for thecluster.The cluster IP address is separate from the server IP address and is required to be on thesame IP subnet as the other servers in the cluster. Storage Device With Shared Media: If you are creating a new cluster, select the devicewhere the Split Brain Detector (SBD) partition will be created.If you have a shared disk system attached to your cluster servers, Novell Cluster Services TMcreates a small cluster partition on that shared disk system. This small cluster partition isreferred to as the Split Brain Detector (SBD) partition. Specify the drive or device where youwant the small cluster partition created.You must have at least 20 MB of free space on one of the shared disk drives to create thecluster partition. If no free space is available, the shared disk drives cannot be used byNovell Cluster Services.If you do not have a shared disk system connected to your cluster servers, accept the default(none). You must create the SBD manually before adding a second server to the cluster.Default: none Optional Device for Mirrored Partitions: If you want to mirror the SBD partition for greaterfault tolerance, select the device where you want to mirror to.You can also mirror SBD partitions after installing Novell Cluster Services.Novell Cluster Services (NCS) Configuration (2) IP Address of this Node: This field contains the IP address of this node. If this server hasmultiple IP addresses, you can change the default address to another value if desired. Start Cluster Services Now: Select this box if you want clustering to start now. If you wantclustering to start after rebooting, or if you want to manually start it later, deselect this box.This option applies only to installing Novell Cluster Services after the OES installationbecause it starts automatically when the server initializes during the installation.If you choose to not start Novell Cluster Services software, you need to either manually startit after the installation, or reboot the cluster server to automatically start it.You can manually start Novell Cluster Services by going to the /etc/init.d directory andentering ./novell-ncs start at the server console of the cluster server.Default: SelectedPage ParameterNovell DHCP Services ConfigurationPage Parameter
