Novell SERVER CONSOLIDATION MIGRATION TOOLKIT 1.1 - ADMINISTRATION GUIDE 12-23-2005 Administration Manual

Contents

Novell SERVER CONSOLIDATION MIGRATION TOOLKIT 1.1 - ADMINISTRATION GUIDE 12-23-2005 Administration Manual Manual pdf 104 page image

104 Novell Server Consolidation and Migration Toolkit Administration GuideThe Source Server Status dialog box displays.10d Verify that the source server is down by selecting Yes.10e Click Next again.This step removes eDirectory from the destination server and deletes the clientconnection.10f Click Next again.This step upgrades eDirectory on the destination server if necessary, restores eDirectoryon the destination server, and prepares to reboot the destination server.10g Reboot the destination server by clicking Next.10h When you are ready to proceed, select Yes > Finish.11 Check the former destination server and verify that it has restarted and taken on the name of thesource server.The server console prompt should display the source server's name.12 Exit the Migration Wizard.The project file is automatically saved.13 Reboot your workstation and log in to the former destination server.This clears old connections from the workstation and establishes a clean connection to theformer destination server.If you can’t log in, refer to Section 12.2, “Workstation-to-Server Connection Problems,” onpage 107.14 Restart the Migration Wizard utility.15 Read the About screen, then click OK.16 Select Open Last Project > OK.The utility verifies that the first three steps of the project file are complete.17 Select Yes when prompted if you are ready to proceed to the fourth step.11.7 Migration Step 4: Finish the NDS/eDirectoryMigrationThe Finish the NDS/eDirectory Migration step upgrades the schema and restores the trustees to thenew server after it has restarted.1 In the Project View dialog box, click Finish NDS/eDir Migration.The Continue NDS/eDir Migration dialog box appears, outlining the eDirectory health checksand other tasks you should complete before continuing.2 To run the NDS/eDirectory backlinker process, go to the destination server console and enterthe following commands:set dstrace=onset dstrace=+blinkset dstrace=*bCheck the Directory Services screen for messages indicating the successful completion of thebacklinker process.