Consolidating Data from NetWare Servers 61run on the server. See Section 6.12.5, “Performing Synchronization or Comparison after a Server-Based Process Project,” on page 62 for more information.After the verification completes successfully, click Proceed in the Start Novell Server ConsolidationUtility dialog box. Instead of copying data, the utility creates the files necessary for server-basedprocessing on all appropriate servers.When the files are ready, a dialog box displays that allows you to view the log files and close theproject.View the success log for a list of the commands you need to run on which servers. The syntax for thecommand is:nuwagent -a "ProjectName"When consolidating to a NetWare server, you run the command on the destination server. Whencopying data from a NetWare server to an OES Linux server, you run the command on the sourceserver.Click Close to exit the Server Consolidation Utility.6.12.3 Launching a Server-Based ProcessConsult the project’s success log file for a list of which commands you need to run on which servers.The success log is located in the project folder (by default, project folders are created assubdirectories under My Documents).The information you need is found in the “End Project Options and Warnings” section of the file. Anexample is shown below:*****************************************************************End Project Options and Warnings.*****************************************************************Server-based process files created on server TEST2. Launch thisprocess at the server console with the command: NUWAgent -a "Project01"At the console of the specified server, enter the command as shown. Be sure to include the quotationmarks around the project name. The command is not case sensitive.Upon completion of the processing, you can check the status in the sys:scu/migerror.logfile on the destination server.IMPORTANT: Allow each server-based process to run to completion before starting anotherserver-based process.For security, after the processing is completed you should delete the XML script that is stored in thesame folder as the project file. The script contains the administrator passwords in obfuscated form.Although the passwords are not written to the file in clear text, a knowledgeable hacker could derivethe passwords from the obfuscated versions.
