Novexx Solutions ALS 20 series User Manual

Contents

Novexx Solutions ALS 20 series User Manual Manual pdf 41 page image

User Manual ALS 20x/256/27207/2017 | 00 41 Product descriptionLabel 3 offset function– Only appears if LABEL SETUP > Multi label mode = „3 labels/start“.– Defines the distance of the 3rd label for the LABEL SETUP > Multi label mode function (see above).The distance is measured from the front label edge of the preceding label.– Setting range: [x…9999.9] mm; Default: x, withx = LABEL SETUP > Label pitch.Miss. label tol. function– Missing label tolerance– The maximum permissible number of successive missing labels on the label strip– Setting range: [0…10] mm; default: 1– See Missing labels  on page 60.Stop count. mode function– Settings: [Enabled, Disabled]Enabled: The dispense counter counts down from the value set in LABEL SETUP > Label stop quan.When the counter reaches 0, no further labels are dispensed.Disabled: The labeller counts up, i.e. each label dispensed increases the counter reading.Label stop quan. function– After this amount of dispensed labels, the dispenser stops– Function only appears, if LABEL SETUP > Stop count. mode = „On“– Setting range: [0…99999]; default: 0MACHINE SETUP menuStore prod.prof. function– Storing a product profile, see Storing a product profile  on page 63.Del. prod.profil function– Deleting a product profile, see Deleting a product profile  on page 64.Dispense counter function– Enables dispense counter (displayed during labelling) to be adjusted by pressing the andkeys.Disp. Cnt. Reset function– Settings: [No, Yes]Yes: Dispense counter is set to zero.No: Dispense counter is not set to zero.Turn-on mode function– Mode the machine is in after being switched on– Settings: [Online, Offline, Standalone]Online: Labelling modeOffline: mode for adjusting settingsStandalone: This mode is used for loading firmware or configurations from externalmemory medium.