NuTone AVDN1 SERIES Installation Use And Care Manual

Also see for AVDN1 SERIES: Additional information Installation use and care manual

Contents

INSTALLATION MANUALINSTALLATION17HORIZONTAL EXHAUST INSTALLATIONVERTICAL EXHAUST INSTALLATIONOTE:N The following procedure applies to both frame or frameless cabinet installations.Install the Hood (EZ1 Bracket)1 ] Run house power cable between service panel and hood location.2 ] There are 2 pairs of recessed holes on each side of the top of the hood (on rear: A and B,on front C and D on illustration below); these holes allow the range hood to hang on thebrackets (previously installed).3 ] Temporarily hang the hood on the brackets using its (2) recessed REAR HOLES (A and B).While holding the hood, run the house power cable into the hood through the strain reliefpreviously installed in step 7 on page 11.4 ] Unhook the rear holes from the brackets and hang the hood using its (2) recessed FRONTHOLES (C and D). Attach power cable to the hood using the strain relief.5 ] Hang the hood on the brackets using the (2) recessed FRONT HOLES (C and D). Tighten anappropriate strain relief, 1/2” diameter (not included) to the power cable, then insert the strainrelief in the knockout hole and secure power cable to the hood.6 ] Connect ductwork to hood and use metal foil duct tape to make joints secure and air-tight.Make sure the damper assembly (or round duct plate) enters the ductwork and that thedamper opens and closes freely.AC BDA BDUCTED INSTALLATION ONLY