NuTone AVDN1 SERIES Installation Use And Care Manual

Also see for AVDN1 SERIES: Additional information Installation use and care manual

Contents

INSTALLATION MANUALINSTALLATION21Connect the Wiring1 ] Connect House Power Cable to range hood wiring: BLACK to BLACK, WHITE to WHITE andGREEN or bare wire under GREEN ground screw.2 ] Reinstall the blower cover plate (shaded part on illustration above) using the lock nut andthe 7 screws previously removed in step 4 on page 10. Pay attention to screw 1 location; fromback of hood point of view, it must be located on left side of the lock nut (see inset).! WARNINGRisk of electric shock. Electrical wiring must be done by qualifiedpersonnel in accordance with all applicable codes and standards.Before connecting wires, switch power off at service panel and lockservice disconnecting means to prevent power from being switchedon accidentally.MOTORSGROUNDWIREHOUSEPOWER CABLEGROUNDSCREW1 234567Install the FiltersDucted Installation Only:Re-install grease filters removed in step 3 , page 10, under “Prepare the Hood”.Non-ducted Installation Only:Purchase two non-ducted filters from your local distributor or retailer (see product specification labelfor filter type). Attach the non-ducted filters following instructions packed with the non-ducted filters.BACK OF HOOD1LOCK NUT

/ 24

Related manuals for NuTone AVDN1 SERIES