NuTone Allure WS1 Series Instructions Manual

Also see for ALLURE WS1 SERIES: Installation instructions Instructions Installation guide Manual

Contents

Page 2ALLURE ® WS1 SERIESRANGE HOOD2 Remove Damper/Duct Connector from inside the hood.Set connector aside - with mounting screws and parts bag.DAMPER/DUCTCONNECTORCABINETBOTTOMCABINET FRONTHORIZONTAL DUCTACCESS HOLE5¼"5¼"7½"1/8 " ¾"1315/16 " (30" hood)1615/16 " (36" hood) 1315/16 " (30" hood)HOODMOUNTINGSCREWS (4)ELECTRICALACCESS HOLE(in wall)3¾"1615/16 " (36" hood)CENTERLINEWOOD SHIMS(recessed-bottomcabinets only)1915/16 " (42" hood) 1915/16 " (42" hood)SOFFIT24" - 30" ABOVECOOKING SURFACECABINET3¼" X 10" DUCT(For horizontal discharge)WALL CAPROOF CAP3¼" X 10"(For verticaldischarge)HOUSE WIRING(Top or Back of hood)HOODHOODHOODPREPARE HOOD LOCATION PREPARE THE HOOD1 Remove tape holding Filters in place. Pull down on filtertabs and lift filters out. Set filters aside.FILTERS1 Determine whether hood will discharge vertically (3¼” x 10”),horizontally (3¼” x 10”) or non-ducted. For vertical orhorizontal discharge, run ductwork between the hoodlocation and a roof cap or wall cap. For best results, use aminimum number of transitons and elbows.2 Use diagrams, below, for proper placement of ductwork andelectrical cutout in cabinet or wall. For a non-ducted installation,DO NOT cut a duct access hole.3 Run house wiring between service panel and hoodlocation.VERTICAL DUCTACCESS HOLE1¼" 1½"10½"5¼"5¼"CENTERLINEHOOD MOUNTING SCREWS (4)ELECTRICALACCESS HOLE(in cabinet bottom)WOOD SHIMS(recessed-bottomcabinets only)CABINET FRONTCABINET BOTTOM1315/16 " (30" hood)1615/16 " (36" hood)7½"5"2"1915/16 " (42" hood)1315/16 " (30" hood)1615/16 " (36" hood)1915/16 " (42" hood)3¼” X 10”VERTICAL DUCTING3¼” X 10”HORIZONTAL DUCTING