NuTone Allure WS1 Series Instructions Manual

Also see for ALLURE WS1 SERIES: Installation instructions Instructions Installation guide Manual

Contents

Page 4ALLURE ® WS1 SERIESRANGE HOODCONNECT WIRINGWARNING: To reduce the risk of electric shock,make sure power is switched off at the servicepanel. Lock or tag service panel to prevent powerfrom being switched on accidentally.HOUSEWIRING(120 VAC)CARDBOARD(Use to protectcooktop)1 Connect House Wiring (120 VAC) to hood. Use a piece ofCardboard to protect the cooktop, if necessary.2 Connect house BLACK to hood BLACK wire, house WHITEto hood WHITE wire, and house ground under GREENGround Screw. Securely tighten cable clamp onto housewiring.GREENGROUNDSCREW3 Replace wiring cover.PREPARE THE HOOD (Continued)10 Remove appropriate Duct Knockout(s) from top or back ofhood.REARRECTANGULARDUCT KNOCKOUT(Remove for 3¼” x 10”Horizontal Discharge)TOP RECTANGULARDUCT KNOCKOUT(Remove for 3¼” x 10”Vertical Discharge)11 3¼” x 10” Ducted Discharge Only: Attach Damper/DuctConnector over knockout opening. Make sure damper Pivotis nearest to Top/Back Edge of hood. Remove Tape fromdamper flap.DAMPER/DUCTCONNECTOR(Vertical dischargeposition shown)TAPENOTE Damper/Duct Connector can be installed up to 1-inchon either side of hood center to accomodate off-centerductwork. In extreme off-center installations, one endof the duct connector may need to be trimmed to clearthe electrical cable clamp.UP TO 1”SIDE-TO-SIDEADJUSTMENTPIVOTTOP/BACKEDGE➙➙