Numerik Jena RIK 4 Manual
                                             | |
Contents
| 
SIMPLY PRECISE186.12 Electromagnetic Compatibility (EMC)Please observe the following to ensure maximum protection against electrical andmagnetic fields:• The encoder must be mounted to a galvanic conductive surface. The mounting surfaces, thethreads of the mounting screws and the threads in the machine must be free from electrically non-conductive coatings.• Maintain the NUMERIK JENA shielding concept for the measuring system!• Shielding for encoders without connectors:- When connected directly with the evaluation electronics, ensure that the external shield of thecable is well grounded- If cable connectors (e.g. terminal strips, etc.) are used, connect the external shields of thecables with each other and with the shielding of the cable connector• When using additional electronics, connect the housing electrically conducting to ensure goodgalvanic conductivity. For insulated installation the housing should be connected at the shortestdistance by an additional potential equalization line (Cu line with cross section ≥6 mm2) with themachine’s protective ground.• Please contact the NUMERIK JENA support or that of the appropriate manufacturer if you experienceany problems when working with specific display or control units.! |
Related manuals for Numerik Jena RIK 4
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine