Nuvico EasyNet ED-P400 Installation Manual

Contents

112SETUP MENUUsing Mouse Click on the different parameters and click to change its value. When finished, make sure thatyou save the settings by clicking on [Save].Using Front Panel/Remote First, use buttons to highlight different parameters on the screen. Then, press ↵button to modify or to get into the sub-menu to change its parameter. When finished, make surethat you save the settings by highlighting [Save] and press the ↵ button.ALARMThe alarm menu allows you set the type of the sensor, the popup, the buzzer, the e-mail and the action for each camera.You can use the external alarm signal to the alarm reset input or the panic record signal.USE: Enable or disable alarm inputTYPE: You can configure it as N/O (Normally Open) or N/C (Normally Closed)ASSIGN: Set the desired option as below.ALARM: 1 to 1 mapping to Alarm Recording under the Record setup menu.PANIC: Can be triggered as PANIC so that the DVR can go into Panic Recording.ACK: Can be triggered or relieve PANIC to acknowledge an event or turn off an event.POPUP: When the popup is on, the camera will pop-up in the monitor during event. See the monitor menu.BUZZER When On, DVR’s buzzer will sound on alarm event.E-MAIL When On, DVR will sends e-mail based on the configuration of NOTIFICATION when alarm is detected.