131SETUP MENUUsing Mouse Click on the different parameters and click to change its value. When finished, make sure thatyou save the settings by clicking on [Save].Using Front Panel/Remote First, use buttons to highlight different parameters on the screen. Then, press ↵button to modify or to get into the sub-menu to change its parameter. When finished, make surethat you save the settings by highlighting [Save] and press the ↵ button.NTPIf an NTP server is available for time sync, enter the appropriate values.NTP Server: Enable this setting if you would like to sync the DVR to the NTP Server and test the connection.Private NTP1: Set IP address of the NTP server if the time server is present in your local network.Private NTP2: Set IP address of the NTP server if the time server is present in your local network.Private NTP3- Set IP address of the NTP server if the time server is present in your local network.Sync Interval: Set the time interval for synchronization.Time Server: If you would like the DVR to act as a time server for other EasyNet™ DVR(s), set it to On.NTP Status: The Sync Status displays the last time the DVR was synchronized with the time server.
