EN-24 Adventurer SLSet the LSDWhen LSD is displayed, press Yes to go toLSD settings, or No to exit.LSD settings are SET 1, SET 2, SET 5, SET 10, SET 100 or SET 0.5.When a setting displays. press No to go to the next setting.Press Yes to accept a setting and exit.End UnitWhen END UNIT is displayed, press Yes toexit the Unit Sub-menu and go to the End Sub-menu, or press No to return tothe first Menu Item in the Unit Sub-menu.3.5.5 End Sub-menuWhen END is displayed, press Yes to exit theMENU and begin weighing, or press No tomove to the Calibration Sub-menu.The first Exponent setting is flashed on the display. The Exponent settings are SET 0,SET 1, SET 2, SET 3, SET -3, SET -2, and SET -1. Press No as each Exponent settingis displayed to display the next setting. When the desired Exponent is displayed,press Yes to accept this Exponent and go to the next variable, LSD.Set the ExponentWhen E appears on the display, press Yes toedit the Exponent. Press No to go to the nextvariable, LSD.Change the ExponentEdit the FactorWhen the Factor is displayed, the first digit is flashing. Press Yes to accept, orNo to display the next incremental value for this digit. When the desired valueflashes, press Yes to accept this value; this will activate the next digit. Press Noto change, or Yes to accept this value. Repeat for the other digits until all digitshave been accepted.Note: To accept the Factor as a whole, each digit must be accepted, even ifthis digit has not been changed.When all digits have been accepted, the new Factor flashes on the display.Press Yes to accept this Factor and display Exponent. Press No to re-edit the Factor.3.5.4 Unit Sub-menu (Cont.)