OHAUS CKW-55 Instruction Manual

Also see for CKW Series: Quick start guide Installation and operation instructions

Contents

OHAUS CKW-55 Instruction Manual Manual pdf 37 page image

CKW-55 CHECKWEIGHER EN-33Print LayoutThis menu determines the format of data output to a printer or computer. Selections are: Formatand Line Feed.FORMATThis menu item is used to define printing format. Selections are:Column (COLUM) = A multi-line (single column style) printout is generated. A CRLF is addedafter each item.Line = A single line printout is generated. (A TAB space is added between eachitem and a CRLF is used only after the very last item.LINE FEEDThis menu item is used to define form feeds. Selections are:Off = No feeds (except for default 1 CR/LF) are appended to the printout.4LF = 4 line feeds are appended to the printout.Form = A form feed is appended to the printout.List Menu SettingsThis menu item is used to obtain printouts of the stored menu parameters and library data..Selections are:MENU = Selections are: No, Yes, (the information is printed immediately one timeon the selection of Yes.Library = This allows print out of the stored Library data. Selections are:No, Yes, (the information is printed immediately one time on theselection of Yes).ENDRepresents the end of the menu.3.6.5 Communication MenuThe Communication menu item is used to configure printing and communications parameters ofthe serial port. All communication is accomplished using standard ASCII characters. Charactersshown in Appendix A, Table A-1, RS232 Command Table are acknowledged by the indicator.The default serial output format is shown below.Field: Polarity Space Weight Space Units Stability CR LFLength: 1 1 7 1 5 1 1 1Definitions: Polarity, “-” sign if negative, blank if positive.Weight, up to 6 numbers and 1 decimal, right justified, leading zero blanking.Units, up to 5 characters.Stability, “?” character is printed if not stable, blank if stable.Note: If the Print Content-Numeric Only is set to On, the Units and Stability fields are omitted.ResetThis menu item is used to reset the Communication menu to factory defaults. Selections are: No, Yes.