OHAUS EB3 Instruction Manual

Also see for EB15: Service manual Service manual Instruction manual

Contents

OHAUS EB3 Instruction Manual Manual pdf 12 page image

EN-6 EB SERIES3.2 Controls and Functions (cont.)• Zeros the display• Initiates setup of Checkweigh parameters: HI and LO range weightor piece count values• moves the active digit to the left when setting up parametervalues• Initiates setup of Counting/Sampling parameters• increments the active digit when setting up parameter values• Initiates setup of Percent weighing parameters• moves the active digit to the right when setting up parametervalues• During parts counting, toggles through piece weight and piececount (in g unit, also displays total weight)4. OPERATIONS4.1 Switching the Unit On and OffThe power switch is located underneath the right-hand side of the scale. Push theswitch to the “I” position to turn the scale on, and to the “O” position to turn the scaleoff. Allow 15-30 minutes for the scale to warm up before use.NOTE: Make sure the weighing pan is empty before turning the scale on.4.2 Manual TareA Tare value in memory is indicated by “TARE” on the display.Place the container on the weighing pan (ex. 100g), then pressTARE.The weight is tared and display will show “0”.To clear the Tare value, press TARE with the pan empty.