EN-8 FrontierTM Centrifuge FC5707Figure. 173.4.3 Preselection of brake intensity and accelerationThis function is activated through the key "Accel/Decel" (6) (refer to figure 18).By pressing the key once the word "accel" (M7) flashes in the display "Acc/Dec" (A-2). The desired accelerationcan be pre-selected by the adjusting dial (4). The value 0 is equivalent to the lowest and the value 9 to the highestacceleration.By pressing the key "Accel/Decel" (6) twice, in the display "Acc/Dec" (A-2), the word "decel"(M8) is shown. Nowthe desired brake intensity can be pre-selected by the adjusting dial (4). The value 9 is equivalent to the shortestand the value 0 to longest possible brake time.See "table 3: acceleration and deceleration times" (APPENDIX). There the acceleration and deceleration timesfor the acceleration and deceleration stages 0 to 9 for permissible rotors are shown.Figure. 183.5 Radius correctionIf you use adapters or reducers it could change the centrifugal radius of the respective rotor. In that case you cancorrect the radius manually. Please proceed as follows:Close the lid, then press the key "Time" (7) (refer to figure 19) and the key "Prog/Setup" (3) at the same time andhold them.In the display "Time/Prog" (A-4) the word "radius" (M9) appears. By the adjusting dial (4) you can preselect therespective radius correction (See Table 5, APPENDIX) in steps of 0.1 cm. As soon as you have set a radiuscorrection the word "radius" (M9) appears. This word will be visible until you put the radius correction back to 0again.479M7 M8 A-2644A-4