OHAUS Scout Series Instruction Manual

Also see for Scout Series: Instruction manual

Contents

OHAUS Scout Series Instruction Manual Manual pdf 10 page image

EN-8 SCOUTTM SERIES BALANCES - SKX4.3 Setup MenuEnter this menu to set balance parameters.Note: Bold always represents factory default value.Reset [reset]Reset the Setup menu to factory defaults.NO = not resetYES = resetFilter [FiLtEr]Set the amount of signal filtering.LOW = less stability, faster stabilization timeMED = normal stability, stabilization timeHI = greater stability, slower stabilization timeAZT [AZt]Set the automatic zero tracking functionality.OFF = disabled0.5d = the display will maintain zero until a change of 0.5 division per second hasbeen exceeded.1d = the display will maintain zero until a change of 1 division per second has beenexceeded.3d = the display will maintain zero until a change of 3 divisions per second has beenexceeded.Stable Range [Stable]Set the amount the reading can vary while the stability symbol remains on.0.5d = 0.5 balance division1d = 1 balance division2d = 2 balance divisions5d = 5 balance divisionsBack Light [b.Light]Sets backlight functionality.OFF = always offON = always onAUTO = turns on when a button is pressed or the displayed weight changes.Note: When connected with power pack, the backlight is always on.Auto Tare [A.tArE]Set the automatic tare functionality.OFF = Automatic Tare is disabledON = the first stable gross weight is taredON-ACC = stable gross loads within the accept limits are tared (in Check weighing mode)Reset: no, yesFilter: Low, Med, HighAuto Zero Tracking: off, 0.5d, 1d, 3dStable: 0.5d, 1d, 2d, 5dBacklight: off, on, autoAuto Tare: off, on, on-accAuto Off: off, 1, 5, 10End Setup: Exit menu