Main steps in calibration#Sub-stepMain step‘2.0 Check the print quality’ on page 101. Check the print qualityContinue only if the colour reference chart does not meet your requirements.‘3.1 Calibrate the EFI controller’ on page 12or‘3.1 Calibrate the Creo controller’ on page 17or‘3.1 Calibrate the Océ PRISMAsync controller’ on page202. Calibrate the controller‘3.2 Check the print quality’ on page 28The result of the controller calibration as checked in 3.2 normally meets the requiredprint quality. If the print quality still does not meet your requirements, you canconsider to proceed with the printer calibration.‘4.1 Perform the adjustment operation’ on page 30 13. Calibrate the printer‘4.2 Adjust the white point (gamma offset)’ on page 331‘4.3 Calibrate the EFI controller’ on page 39 2or‘4.3 Calibrate the Creo controller’ on page 44 2or‘4.3 Calibrate the Océ PRISMAsync controller’ on page472‘4.4 Check the print quality’ on page 55Note:1 Calibration of your copy process only requires step 4.1 and 4.2.Note:2 Calibration of the printer requires calibration of the controller because the controllertakes the printer settings into account at controller calibration.Chapter 1 - Introduction8Main steps in calibration