Oce VarioLink 9522 User Manual

Also see for VarioLink 9522: User guide User guide

Contents

VarioLink 9522 (Version 2) 9-19PostScript PPD printer driver setting (Mac OS X) 9Tandem ModeUsing two printing systems (master copier and sub copier), prints can be made at the same time under thesame printing conditions. When printing a large number of copies, time required to complete the job can beshortened.When either one of the two copiers is equipped with a image controller, tandem printing can be performed.When both of the copiers are equipped with a image controller, the copier which receives the printing jobinstruction functions as the master copier and the other one is the sub copier.For the tandem printing, the two copiers should be connected by either method as follows.- Connect the two copiers directly with a cross cable. In this case, the network functions cannot be used.- Connect them with a straight cable via HUB.2 NoteUse a cross cable or straight cable higher than the category type 5.Tandem printing should only be set up by your authorized service representative.Refer to the "User’s Guide (POD Administrator’s Reference)" for more information about Tandem Mode.Tandem Mode cannot be set in the following cases:- When [Transparency Interleave] is selected.- When [Enhanced Security] is set to ON.Output TraySelects the output tray.Each of them can/cannot be set in the following cases:- Each options which is not selected on the [Printer Info] window cannot be set.- When [Staple] is available, any item other than [Default] and [Main Tray] can not be set.Face Up/DownSelects the output order.- [Face Down] outputs paper with the printed side facing down.- [Face Up] outputs paper with the printed side facing up.N to 1The [1 to N] outputs paper starting with the first page.The [N to 1] outputs paper starting with the last page.Binding PositionSets the binding position for the document to be printed. The position selected here will be the position ofstapling, punching and base position of the image shift.Master copierSub copier