| 
183 Make Fax Settings (imageRUNNER 1025iF Only)The receive mode determines how the machine responds to incoming faxes and voice calls. Select the mode thatmost suits your needs from the chart below. For more information about the receive modes, see “About theReceive Modes,” on p. 17.The remote reception function is useful when the receive mode is set to and your machine is connected to an externaltelephone. You can receive faxes by picking up the external telephone and pressing a two-digit remote reception ID (the defaultsetting is 25). For details, see “Fax,” in the e-Manual.Your telephone with built-in answering machine or answering machine must be connected directly to the machine to use Mode>. (See “Connect Telephone Cables,” on p. 14.) Make sure that the auto answering function of the telephone built-in answeringor answering machine is activated.The external telephone must be connected to the machine to use or . (See “Connect Telephone Cables,” on p. 14.)By default, is selected in . If an external telephone is connected to the machine and receives a fax or voicecall, the external telephone rings. You can answer voice calls while the external telephone is ringing .To disable the incoming ring, press [Additional Functions] → → → →, then select .Voice mail is not supported with .DRPD (Distinctive Ring Pattern Detection) service assigns two or more telephone numbers with distinctive ring patterns to a singletelephone line, allowing you to have both a fax number(s) and a telephone number(s), using only one telephone line. Your machineautomatically monitors incoming calls and the ring pattern, to let you know if the call is fax or voice call. Set the ring patternsassigned by your telephone company for a fax or voice call. Contact your telephone company for information on availability.–––––––The display returns to the standby mode:The machine may enter the standby mode (Auto Clear function) while you aresetting it up. Make the setting again from the main menu.The display turned off:The machine may enter the sleep mode while you are setting it up. Press[Power] to turn the machine back ON and continue the setup.1 Press [Additional Functions].2 Press [ ] or [ ] to select <3. TX/RXSETTINGS>, then press [OK].3 . T X / R X S E T T I N G SA D D . F U N C T I O N S3 Press [ ] or [ ] to select <2. FAX SETTINGS>,then press [OK].2 . F A X S E T T I N G ST X / R X S E T T I N G S●●4 Press [ ] or [ ] to select <3. RX SETTINGS>,then press [OK].3 . R X S E T T I N G SF A X S E T T I N G S5 Press[ ] or [ ] to select <2. RX MODE>, thenpress [OK].2 . R X M O D ER X S E T T I N G S6 Press [ ] or [ ] to select the receive mode,then press [OK].7 Press [Stop] to return to the standby mode. |
