7 - EnglishMaterial Safety Data Sheet#58402801/58402801Black Toner, Type B2 : P/N 44574701(B411/B431), 44574901 (B431)For more information, contact Oki Data at: 2000 BishopsGate Boulevard, Mount Laurel, NJ 08054-4620.Emergency Information: call 1-800-654-3282; US andCanada only.Emergency First Aid ProceduresToner inhaled.Remove person to fresh air. Seek medical attention.Toner swallowed (ingested)Immediately seek medical attention. Never giveanything by mouth to an unconscious person. Ifpossible, rinse out mouth and give one or two glassesof water or milk to drink.Toner gets in the eyes.Flush eyes with large quantities of cool water for 15minutes, keeping the eyelids open with fingers. Ifnecessary, seek medical attention.Toner gets on the skin.Wash toner off the skin with plenty of cool water andsoap. If necessary, seek medical attention .Note: Small amounts of toner on skin or clothing caneasily be removed with soap and cold water. Hotwater makes toner harder to remove.Hazardous IngredientsPolyester (about 70-95% by weight)CAS#: Trade Secret.OSHA TWA: Not established .ACGIH TLV: Not established.LD50 : Not available.LC50 : Not available.Carbon Black (about 2-6% by weight)CAS#: Trade Secret.OSHA TWA: Not established .ACGIH TLV: Not established.LD50 : Not available.LC50 : Not available.Silica dioxide (about 1-5% by weight)CAS#: Trade Secret.OSHA TWA: Not established .ACGIH TLV: Not established.LD50 : Not available.LC50 : Not available.Physical DataPhysical State: Solid.Melting/Freezing Point: Not available .Boiling Point: Not available.PH: Not available.Vapor Pressure: Not available.Vapor Density (Air=1): Not available.Evaporation Rate (Butyl Acetate=1): Not available .Specific Gravity (H 2O=1): 1.1 to 1.2 at 20°C (68°F).Solubility in Water: Not available.Solubility in Solvents: Some components are solublein toluene, chloroform and tetrahydrofuran.Coefficient of water/oil Distribution: Not available.Appearance and Odor: Black powder, no odor.Odor Threshold: Not available .Fire and Explosion Hazard DataMinimal fire hazard. Large quantities may cause risk ofdust explosion.Flash Point (Method Used): Not available.Flammable LimitsLower Explosive Limit: Not available.Upper Explosive Limit: Not available.Auto-Ignition Temperature: Not available .Explosion DataSensitivity to Mechanical Impact: Not available.Sensitivity to Static Discharge: Not available.Extinguishing Media: In case of small fire, use CO2.In case of large fire, shut off air by spraying withwater or foam.Special Fire Fighting Procedures: Fight fire fromupwind position. Avoid inhalation of smoke or gases.Wear self-contained breathing apparatus.Hazardous Combustion Products: Not available .Toxicological PropertiesRoutes of Entry: Inhalation, Ingestion, Eyes, Skin .Effects of Acute Exposure: Not available.Effects of Chronic Exposure: Not available.Exposure Limits: Not available.Irritancy: Not available.Sensitivity: Not available.CarcinogenicityIARCSilica Dioxide: Group 3, "Not classifiable."Carbon Black: Group 2B, "Possible Carcinogen. "NTP: No components are listed.OSHA: No components are listed.Reproductive Toxicity: Not available.Teratogenicity: Not available.Mutagenicity: AMES test (TA98, TA100, TA1535,TA1537, WP2uvrA)Name of Toxicoligically Synergistic Products: Notavailable.Reactivity DataStability: Stable in general .Conditions to Avoid: Avoid excess heat and allsources of ignition.Polymerization: Will not occur.Hazardous Decomposition or Byproducts:Combustion products include harmful gases such ascarbon monoxide and nitrogen oxides.Incompatibility: Not available.Preventive MeasuresPersonal Protective EquipmentRespiratory Protection: Not normally required. Forlarge spills, use dust respirator during cleanup.