English1. Unpack the serial card andremove any shipping materials.2. Turn off the printer. Removethe power cord and interfacecable.3. Remove the access panelscrew.4. Lift off the access panel.5. Install the Serial InterfaceCard:a. Align the connector at the bot-tom of the card with the con-nector on the main board.Note: It helps to align the screwholes (1) to position the cardcorrectly.b. Press the card down until theconnectors are fully engagedand the card is securelyinstalled.6. Insert and tighten the screws.7. Replace the access panel:a. Snap off the breakout tab .b. Align the tabs at the panelbottom with holes in printerframe.c. Swing panel up and into place.d. Replace the screw.8. Verify the installation:Print a MenuMapa. Press the Menu button one ormore times until INFO.MENUappears on the display.b. Press SELECT twice. TheMenuMap prints.c. RS232C MENU should appearin the second column. If itisnít there, check to be surethat the card is installed cor-rectly.To change RS232-C settings:See the Userís Guide on the CDincluded with your printer forinstructions to select interfacesettings in the printer Menu.English . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1FranÁais. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2EspaÒol . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3PortuguÍs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 458366402For RS232-C Serial Interface CardInstallation InstructionsDirectives d' installationInstrucciones de InstalaciÛnInstruÁıes de instalaÁ„o© 2009 Oki Data Americas, Inc