11 / EnglishYou may be required to enter the IP address for theprinter. The IP address can be found on the MenuMap(printed earlier).Test the Printer Driver InstallationTo make sure the printer driver is correctly installed,print a page from any program. Reinstall the driver ifthe installation failed.Activate Optional AccessoriesNote: If your printer has an optional paper tray orHard Disk Drive installed, you must enter thedriver and activate it.1. Click Start > Settings > Printers (and Faxes) onthe Windows taskbar.2. Right click the printer icon.3. Click Properties.4. Click the device Option tab.5. Click [Get Information From Printer].This will update installed device options and makethem available.Set the Printer Configurations via aWeb PageIf you are working in a network environment, you canuse a web browser to display the printer or job printingstatus and to change the settings.Settings for the system and network ports can beconfigured under [Printer], [Network] and[Maintenance] on the web page.1. Boot your computer, and start the web browser.2. Enter the printer’s IP address or URL in theaddress input column on the web browser andpress the key.The IP value can be found on Page 1 of the printedMenuMap under the heading “Network” (seeinstructions for “Print a MenuMap” on page 10).IP Address = ###.###.###.###When entering this number into the address of thebrowser you may omit leading zeros.Installing the Printer on aUSB PortInstall the Driver1. Turn the printer OFF.2. Insert the CD, in the CD-ROM drive. The CD willautorun.If it doesn’t, click Start > Run > Browse. Browse toyour CD-ROM drive, double-click Setup. Click OK.3. Select your language. Accept the licenseagreement.4. Click Install Driver.5. Select local printer.6. Follow the on-screen instructions.7. When prompted, select printer emulation (PS orPCL).8. When prompted, connect the USB cable and switchthe printer ON.Test the Printer Driver Installation1. Click Start > Printers, and check to see if theprinter icon is present.2. If not, reinstall the driver.3. If the Printer icon is there, highlight the icon andright click Properties, then click the Print Test Pagebutton.A single test page should print.If the test page does not print:• Check to see if the printer displays “Ready to Print”.• Check for appropriate cable connections betweenthe printer and the PC or Network.If Printer Displays “Ready to print” and the cableconnections are good, then reinstall the driver.If this does not correct the problem, refer to the on-lineUser Guide supplied on the CD which came with theprinter for further troubleshooting instructions.NOTE> The web page facility is only availablewhen the printer is connected to thenetwork.> Refer to the Network User’s Guide if theweb page does not appear after carryingout the steps 1 and 2 below.NOTEFor the USB interface, install the driver beforeinstalling the USB cable.
