Oki B820N Setup Instructions

Also see for B820N: User manual

Contents

902 Basic OperationUser Menu2 Basic OperationCategory Item Value Function / Notes B840dn B820nNETWORKMENUSNMP ENABLEDISABLESets SNMP of FTP."ENABLE" is selected in "TCP/IP" or "NETWARE".○ ○NETWORKSCALENORMALSMALLNORMAL: When NORMAL is selected, it can workeffectively even when it is connected to HUBthat has a spanning tree feature. However,printer start up time gets longer whencomputers are connected with two or threesmall LANs.SMALL : When SMALL is selected, computers can coverfrom two or three small LANs to a large LAN,but it may not work effectively when it isconnected to HUB with a spanning tree feature.○ ○HUB LINKSETTINGAUTO NEGOTIATE100BASE-TX FULL100BASE-TX HALF10BASE-T FULL10BASE-T HALFSets a method to link with HUB.When Auto is set, a connection method to HUB is selectedautomatically and attempts to connect.○ ○FACTORYDEFAULTSEXECUTE Specifies whether to initialize the network menu or not. ○ ○MEMORYMENU※7RECEIVE BUFSIZEAUTO0.5MB1MB2MB4MB8MB16MB32MBSets the size of receive buffer.The maximum selection that Menu displays is equal to thefollowing formula or smaller.○ ○RESOURCESAVEAUTOOFF0.5MB1MB2MB4MB8MB16MB32MBSets the size of resource saving area.The maximum selection that Menu displays is equal to thefollowing formula or smaller.○ ○SYS ADJUSTMENU※8X ADJUST 0.00MILLIMETER+0.25MILLIMETER～+2.00MILLIMETER-2.00MILLIMETER～-0.25MILLIMETERAdjusts the position of a whole print image in the directionthat is perpendicular to the direction paper runs, that ishorizontally (at 0.25 mm pitch).Any parts of the print image that go beyond the printablearea as a result of this designation are clipped.When the PCL printer driver [Job Options] tab, the printmode is set to PCL mode, this setting is valid.○ ○Y ADJUST 0.00MILLIMETER+0.25MILLIMETER～+2.00MILLIMETER-2.00MILLIMETER～-0.25MILLIMETERAdjusts the position of a whole print image in the directionpaper runs, that is vertically (at 0.25mm pitch).Any parts of the print image that go beyond the printablearea as a result of this designation are clipped.When the PCL printer driver [Job Options] tab, the printmode is set to picture mode, this setting is invalid.Correction in negative values is invalid in PS Mode.○ ○SYS ADJUSTMENU※8DUPLEX XADJUST0.00MILLIMETER+0.25MILLIMETER～+2.00MILLIMETER-2.00MILLIMETER～-0.25MILLIMETERAt the time of back page printing of Duplex, adjusts theposition of a whole print image in the direction paperruns, that is vertically (at 0.25mm pitch).Any parts of the print image that go beyond the printablearea as a result of this designation are clipped.When the PCL printer driver [Job Options] tab, the printmode is set to picture mode, this setting is invalid.Duplex unit is installed.○ ○※7 Set [ADMIN MENU] - [OP MENU] - [MEMORY MENU] as "ENABLE", all items of setting under the MEMORY menu display.※8 Set [ADMIN MENU] - [OP MENU] - [MEMORY MENU] as "ENABLE", all items of setting under the MEMORY menu display.