C6000n User’s Guide107Network MenuNote: Factory default settings are shown in bold.Item Settings ExplanationTCP/IP ENABLEDISABLEEnables or disables this networkprotocol.NETBEUI ENABLEDISABLEEnables or disables this networkprotocol.IP ADDRESSSETAUTOMANUALChange this to Manual to specify the IPaddress through the front panel (seenext entry). Required for non-DHCPnetworks.IP ADDRESS xxx.xxx.xxx.xxxDefault =198.168.100.100Current assigned IP address. Tochange:• Press ENTER.• Use +/– keys to increment firstoctet.• Press ENTER to move on to the nextoctet.• Use +/– keys to increment secondoctet.• Press ENTER to move on to the nextoctet.• Use +/– keys to increment thirdoctet.• Press ENTER to move on to the lastoctet.• Use +/– keys to increment 1stoctet.• Press ENTER to register the newaddress.SUBNET MASK xxx.xxx.xxx.xxxDefault =255.255.255.000Current assigned subnet mask. Tochange, proceed as above.GATEWAYADDRESSxxx.xxx.xxx.xxxDefault =192.168.100.254Current assigned gateway address. Tochange, proceed as above.Factory Default [EXECUTE] Initializes the network card.WEB/IPP ENABLEDISABLEEnables or disables Web config. facilityand Internet Printing Protocol.This item will not appear in the menu ifTCP/IP is set to DISABLE.
