Windows> 16settings from within the Control Panel. If TCP/IP has notbeen installed refer to the section below Installation ofTCP/IP protocol.2. If not already configured, a suitable IP address, SubnetMask and Gateway address should be configured. Ifnecessary, refer to Microsoft On-line Help.3. If your network environment uses domain names, DNSshould be enabled and configured on your system.However, this step is not essential to enable networkprinting.4. Restart the operating system.CONFIGURING WINDOWS TO USE TCP/IP NETWORKINGWINDOWS 98/ME1. Select Start -> Settings -> Control Panel.2. In the Control Panel, double-click on the Network icon.3. In the “Network” dialog box, click the Configuration Panel.4. If “Client for Microsoft Networks” is not listed, click theAdd button.5. In the “Select Network Component Type” dialog box,select Protocol and click the Add button.6. In the “Select Network Protocol” dialog box, selectMicrosoft from the list of manufacturers and select TCP/IPfrom the list of network protocols. Click OK.7. Click OK in the “Network” dialog box. You may beprompted for the Windows installation CD-ROM.8. Follow the remaining dialog box prompts.CAUTION!The IP address entered must be unique and valid.Entering an incorrect IP address may cause severenetwork problems. You can check the address withthe network administrator.