43827101TH Rev.2 142 /Oki Data CONFIDENTIAL6. Press the [BACK] key (except for the status of Item 4.) to terminate the setup. (Status of Item 1restored)K ** ** ** ****xxxxxxxxxxxxx** ** ** **** : Rev No.xxxxxxxxxxxxx : Serial No.IndicationTONER SENSORBELT UNIT CHECKID UNIT CHECKREG ADJUST ERRORDRUM OVER LIFEOperation of set valueDetects.Does not detect.ChecksDoes not check.ChecksDoes not check.Detect.Stops.Does not stop.Does not extend life.Extends life.FunctionFor enabling/disabling toner sensor operation.For enabling/disabling checking operation formounted belt unit.For enabling/disabling checking operation formounted ID unit.For enabling/disabling the stop of error issuance,based on color drift detection value.For enabling/disabling extending the drum life.Set valueENABLEDISABLEENABLEDISABLEENABLEDISABLEENABLEDISABLESTOPCONTINUANCEHatched part: Denotes the default.5.3.2.12 Indication of LED head serial numberThis self-diagnosis is practiced to check whether a downloaded LED head data matches the serialnumber of the actual LED head.1. Activate the self-diagnostic mode, and press and hold down the [MENU+] key or [MENU-] key,until "LED HEAD DATA" appears in the upper line of the display section, and then, press theENTER key. (The MENU+ key increments a test item, and the MENU- key decrements a testitem.)2. Pressing the [MENU+] key or [MENU-] key causes the serial numbers of the K/Y/M/C LEDhead data to be displayed sequentially.3. Press the [BACK] key to terminate the test. (Status of Item 1 restored)Display PartUpperDisplay Part lowerSettingMethodSetNumberSetValueDeteilsRange OfSelectionInitialingValueWR POINTREVBOTTOM WRTPOINT--TBL=**HTBL=**H±=*.***mm±=*.***mm00H~FFH00H~FFH0.000mm(00H)00H~FFH(00H)The correction value isadded to the predeterminedwriting positionThe amount of the form rearend cutting is set
