43827101TH Rev.2 38 /Oki Data CONFIDENTIAL3. INSTALLATION3.1 Cautions, and do's and don'ts• Do not install the printer at high temperature or near fire.• Do not install the printer in a location where chemical reaction can take place (laboratory, etc.).• Do not install the printer in the proximities of inflammable solvents, such as alcohol, paint thinner,etc.• Do not install the printer within reach of small children.• Do not install the printer in an unstable location (e.g., on a rickety bench or grade).• Do not install the printer in a location laden with moisture or heavy dust, or in direct sun.• Do not install the printer in an environment with sea wind or corrosive gas.• Do not install the printer in a location with heavy vibration.• In the event that the printer is inadvertently dropped or its cover is damaged, remove the powerplug from the power outlet and contact Customer Center.Such mishap could lead to an electric shock, fire or injury.• Do not connect the power cord, printer cable or grounding wire in any other manner than the wayspecified in the manual. Failure to observe the above could result in fire.• Do not stick in an object into the vent hole.Such action could lead to an electric shock, fire or injury.• Do not place a glass filled with water or the like on the printer.Such action could lead to an electric shock or fire.• When the printer cover has been opened, do not touch the fuser unit.Burns could be suffered.• Do not throw the toner cartridge or the image drum cartridge into fire.Dust explosion could cause burns.• Do not use a highly combustible spray near the printer.Fire could be caused, since the printer contains a part that gets extremely hot inside.• In the event that the cover becomes unusually hot, emits smoke, ill odor, or abnormal noise,remove the power plug from the power outlet and contact Customer Center.Fire could break out.• If water or any other liquid enters the inside of the printer, remove the power plug from the poweroutlet and contact Customer Center.Fire could break out.• If a pao not operate or disassemble the printer in any other manner than the way specified in themanual.Failure to observe this warning could result in an electric shock, fire or injury.
