11-4 Connecting to the NetworkQuick path to installationThe diagrams on the following pages show typical systems you can use to print and runFiery software from remote workstations. Find the page with your preferred platformand network type, and then look up the setup procedures referenced in the “Key tosetup” in the upper-left corner of each diagram.The diagrams describe devices that use the supported networking protocols. They arelogical diagrams and are not intended to describe the physical arrangement (topology)of devices on the network. A variety of physical arrangements is possible with eachlogical arrangement. For example, twisted pair Ethernet networks commonly use a starconfiguration around a hub, rather than a bus arrangement. The design of physicalnetworks is beyond the scope of this manual.If your network uses more than one protocol or more than one type of workstation,combine the setups listed for each component of your system. Multiple protocols(shown in the diagrams as parallel lines) can run on the same cable. A solid connectionfrom the Fiery with an arrow indicates that other supported network types can beoperational at the same time.The protocols used in these diagrams are indicated as follows:AppleTalkIPX (Novell)OtherTCP/IP (lpd,nbt, or http)Parallel
