44-7 Network Setup optionsNetwork Setup optionsWhen you perform Network Setup, you configure the Fiery to receive print jobs overthe network systems used at your site.In the Setup menu, choose Network Setup, to specify network addresses and names tobe used by workstations, servers, and the Fiery when they communicate with eachother.The Network Setup menu includes three submenus that allow you to choose porttypes, protocols, and network services. You must perform Port Setup and enable atleast one port. When multiple ports are enabled, print jobs can be received over all ofthose ports at the same time. If the Fiery is configured to enable more than oneprotocol, it automatically switches to the correct protocol when it receives a print job.For each item you enable, you are prompted to enter settings for that item. Defaultvalues, where applicable, appear in this manual with square brackets.You should display and select options only for the network systems that are currentlyused at your site. If your network requirements change, you can change Network Setupat any time.The available network types, and the Setup areas that pertain to them, are summarizedin the following table.For this Network orConnection TypeUse thisPort Setup Use this Protocol Setup Use this Service SetupAppleTalk over Ethernet Ethernet Setup AppleTalk Setup AppleTalk printing (PAP) isenabled automatically.TCP/IP over Ethernet Ethernet Setup TCP/IP Setup: Ethernet Setup LPD SetupWeb Services SetupWindows SetupPort 9100 SetupIPP SetupIPX/SPX over Ethernet Ethernet Setup IPX/SPX Setup PServer Setup (NDS, Bindery,or both)
