Oki C9800hdn Software Installation Manual

Also see for C9800hdn: Safety and regulatory information Regulatory and safety information Installation instructions Limited warranty Limited warranty

Contents

11-49 Using Fiery utilities for the first timeUsing Fiery utilities for the first timeBefore you can use the newly installed software, you must configure the connection tothe Fiery.Configuring the connection for Fiery utilitiesThe first time you start one of the Fiery utilities, you must configure the connection tothe Fiery. Similar configuration is used for all Fiery utilities, so a change in oneconfiguration affects all the other connections. Configuration for most Fiery utilities isdescribed in the following procedure.For configuration of specific Fiery utilities, see “Configuring the connection forCommand WorkStation” on page 1-51.B EFORE YOU BEGIN• Print the Configuration page from the C9800 Control Panel.This page contains information you need when configuring the connection, such asthe IP address. For TCP/IP installations, you can use the DNS name of the Fieryinstead of the IP address. Make sure the Fiery is already registered in a Domain NameServer (DNS) on your network. For more information, see your Windows systemdocumentation.TO CONFIGURE THE CONNECTION FOR F IERY UTILITIES1. Start the utility for which you want to configure a connection.For details, see the Printing Guide.2. If the No Servers Configured dialog box appears, click OK.If the Choose Printer Device dialog box appears, click Add.3. Enter the appropriate information for the Fiery.Nickname—Enter a name for the Fiery. This name does not have to match the actualServer Name of the Fiery.N OTE : The nickname cannot contain any of the following seven characters:[ ] _ " '