Oki C9850 Maintenance Manual

Also see for C9650 Series: User guide Brochure & specs Network and Configuration Guide User guide User guide

Contents

Oki C9850 Maintenance Manual Manual pdf 65 page image

Oki Data CONFIDENTIAL43627911TH Rev. 3 65 /3.5.2 Power Cable ConnectionConditions for Power Supplies• The following conditions apply to the power supplies of printers:Alternate Current (AC) : 100 V ±10%Power Supply Frequency : 50, or 60 ±2 Hz• For unstable power supplies, use voltage regulators etc.• The maximum power consumptions of printers are 1,500 W. Be sure power supplies havepower supply capacities adequate for the printers.Well explanation and showing the customers a user’s manual avoids any troubles.It may expose you to electric shocks or cause a ire.• Make sure to turn off printers before attaching and detaching power supply cords andgrounding wires to the printers. Keeping the power supply ON causes a ire or an electricshock.• Grounding wires must be connected to dedicated grounding terminals. No grounding wirescauses a ire or an electric shock. Consult with a dealer if grounding wires is impossible.• Never connect the ground wires to water or gas pipes, or telephone grounds, lightningconductors or other lines. They cause a ire, an electric shock or a gas explosion.• Always hold a plug while inserting or removing the power supply cord. Damaged cord is aresult of pulling it, which causes a ire or an electric shock.• Do not insert or pull out power supply plugs with wet hands. Make sure the power supplycord is well inserted. Otherwise causes a ire or electric shock.• Do not insert or pull out the power supply plugs with wet hands. It causes an electric shock.• Do not step on the power supply cord or put the things on them. Otherwise damages the cordand causes a ire and an electric shock.• Do not tie the power supply cords in a bundle in use of the printer. It heats up and damagesthe cord, which is a result of a ire and an electric shock.• Do not use the damaged power supply cords. It causes a ire or an electric shock.• Do not use star-burst connections for printers.• Do not connect a printer to the same receptacle outlet being used for electrical equipmentother than the printer. Connecting a printer such a receptacle outlet, particularly being usedfor air conditioning, copying or shredding equipment, may cause a malfunction in the printerdue to electrical noises. If a printer is connected to such a receptacle outlet by necessity, usea commercially available noise ilter or noise-cut transformer.• Do not use the extension cords. Normal printer operation may not be attained if using anextension cord due to the decreased AC voltage. If necessary, select the cord, which is rating100 V, 15 A and more. Other types of cords cause a ire or an electric shock.• Do not turn off the printer or pull out the power supply plugs while the printer are in use. Itcauses of a broken down of printer or an electric shock.• Please disconnect printers from the mains supply if they will not be used for an extendedperiod of time for safety.• Use only those attached cord.Using other types of cords cause a ire or an electric shock.• Do not use an attached cord to other appliances due to a ire or an electric shock.