Oki ES5432 Advanced Manual

Also see for C532: User manual User manual

- 122 -5. Operating Management/ Specifications• Power Save• Memory Setup• Flash Memory Setup* 1• Storage Maintenance Setup• Language Maintenance Setup• Job Cancel SetupAllow All Reports To Print Disable Sets whether to allow printing reports withpersonal information.Near Life LED Enable Sets whether to light an LED if a near lifewarning occurs.Near Life Status Enable Sets whether to display a message if a nearlife warning occurs.Status Display Toner Gauge Specify display information in idle Display.Paper Size: Display paper size of each tray.Toner Gauge: Display toner gauge.Panel Contrast 0 Sets the contrast of the display screen.USB Memory Interface Enable If [Disable] is set, the print from USB Memoryfunction cannot be used.Item Factory default setting DescriptionPower Save Time 1 minute Sets when to enter Power Save mode.Sleep Time 15 minutes Sets when to enter Sleep mode.Auto Power Off Time 4 hours Sets when to enter Auto Power Off.Silent Mode ON Specifies a print preparation operation whenentering standby status from Sleep mode.If [ON] is set: it is quiet as there is no printpreparation.If [OFF] is set: there is a rotation noise of theimage to perform print preparation but youcan start first printing early.ECO Mode*1 ON If [ON] is set: Printing starts even before thetemperature of the fuser reaches theprescribed degrees, if the job is small.If [OFF] is set: Printing starts after thetemperature of the fuser reaches theprescribed degrees.Item Factory default setting DescriptionReceive Buffer Size Auto Sets the reception buffer size that localinterface secures.Resource Save OFF Sets the resource save area.Item Factory defaultsettingDescriptionItem Factory defaultsettingDescriptionInitialize Execute Initializes a flash memory.This item is displayed when [Initial Lock] isset to [Disable].Format Partition PCL (NULL) Formats a partition.Common (NULL)PS (NULL)Item Factory default setting DescriptionCheck File System Execute Resolves any mismatch between actualmemory and displayed memory available in afile system and performs administration data(FAT information) recovery.Initial Lock Enable Sets whether to give permission to changesettings associated with the memoryinitialization.Item Factory default setting DescriptionSelect Language English Selects display language for the displayscreen.Initialize*1 Execute Deletes downloaded message files.Item Factory default setting DescriptionCancel Key Behavior Short Sets the behavior when the (CANCEL)button is pressed.Short: Pressing the button for less than2 seconds cancels the job.Long: Pressing the button for 2 to 5 secondscancels the job.Off: Pressing the (CANCEL) button doesnot cancel the job.Inquiry Display On Sets whether to display the confirmationscreen when cancelling the job.Focus Position Yes Sets an option between "Yes" and "No" to behighlighted on the confirmation screendisplayed when cancelling the job.