Chapter 1 PREPARATIONSDescription of Each ComponentThis section describes the names and operations of the equipment, control panel and touch panel.61. Reversing Automatic Document Feeder(optional, MR-3022)The stack of originals is scanned one sheet at a time. Bothsides of the originals can be scanned. A maximum of 100sheets (80 g/m2 or 20 lb. Bond) can be placed in one go.(The maximum number of sheets that can be set may varydepending on the media type of the originals.)2. Operator’s Manual Pocket (back side, optional,KK-1660)Keep the manual in this pocket.3. USB terminal (4-pin)Use this terminal when connecting this equipment to a PCwith a commercially available USB cable.4. Network interface connectorUse this connector when connecting this equipment to anetwork.5. Automatic duplexing unitThis unit makes copies on both sides of the paper. Open itwhen paper jams occur.6. Bypass trayUse this to perform printing on special media types suchas OHP film, etc.P.23 “Bypass copying” in this manual7. Paper holding leverUse this to locate paper on the bypass tray.8. Paper feed coverOpen this cover when releasing paper misfed in thedrawer feeding area.9. Paper feed cover (optional)Open this cover when releasing paper misfed in the PaperFeed Pedestal (optional) or Large Capacity Feeder(optional).10. Paper size indicatorThe size of the paper set in the drawer can be checked.11. Paper Feed Pedestal (optional, KD-1025) andAdditional Drawer Module (optional, MY-1033)or Large Capacity Feeder (optional, KD-1026)Use the Paper Feed Pedestal to add one drawer. TheAdditional Drawer Module (optional) can be installed inthis device.A maximum of 2000 sheets (80 g/m2 or 20 lb. Bond) ofplain paper can be placed in the Large Capacity Feeder.12. DrawerA maximum of 550 sheets of plain paper can be placed inone go.P.15 “Placing paper” in this manual13. Front coverOpen this cover when you replace the toner cartridge andclean the charger.Front / Right side1312111015678934Back side2