2.PRINTING FROM WINDOWSPrinting With Best Functions for Your Needs 1072 PRINTING FROM WINDOWS StaplingYou can staple sets of paper to exit from the equipment.Stapling is not available if a Finisher is not installed.Stapling the paper1 Display the [Finishing] tab menu.2 Select the [Staple] check box. Select a stapling option.Upper Left — Select this to staple the printed document at the upper left.Upper Right — Select this to staple the printed document at the upper right.Center Top — Select this to double-staple the printed document along the top edge.Middle Left — Select this to double-staple the printed document along the left side.Center Double — Select this to fold and double-staple the printed document in the center.y The selectable options vary depending on the paper size.y [Center Double] can be selected only when the Saddle Stitch Finisher is installed and configured on the[Device Settings] tab.3 Set any other print options you require and click [OK].4 Click [OK] or [Print] to send the print job.The output is stapled for each copy. Hole punchingSelect this to punch holes on printed sheets of paper to exit from the equipment.Hole punching is not available if a Hole Punch Unit is not installed.Punching holes1 Display the [Finishing] tab menu.2 Select the [Hole Punch] check box. Select a hole punch option.Center Top — Select this to punch holes along the top edge.Middle Left — Select this to punch holes along the left side.3 Set any other print options you require and click [OK].4 Click [OK] or [Print] to send the print job.Holes are punched.