Oki MC352 Startup Manual

Also see for ES3452 MFP: User guide Startup guide User guide

Contents

Oki MC352 Startup Manual Manual pdf 80 page image

- 80 -Scanning to Local PC4 Scanning13 When the instruction to connect themachine to the computer and turn onthe machine is displayed, plug the otherend of the USB cable into the computer’sUSB interface connector and hold downthe power switch for approximately onesecond to turn on the power.Note● Do not plug the USB cable into the network interfaceconnection. Doing so may damage your machine.14 Click the [Exit] button.15 Remove “Software DVD-ROM” from thecomputer.The installation is complete. For WSD Scan ConnectionTo configure the Scan to Local PC via the WSDScan connection, follow the 2 steps below:● “Step 1 Configuring the Network Settings ofYour Machine” P.80● “Step 2 Installing Your Machine to theComputer” P.83Note● You need to configure the network setting of the computerbefore this procedure.Memo● You can skip the step 1 if the IP address is already set onyour machine. Step 1 Configuring the NetworkSettings of Your MachineConnect your machine to a network with anEthernet cable, and then configure the machine’sIP address and other network information fromthe operator panel. You can set the IP addresseither manually or automatically.If there is no DHCP server or BOOTP server onthe network, you need to manually configure theIP address on the computer or machine.If your network administrator or internetservice provider specifies a unique IP addressfor the computer and your machine, set the IPaddresses manually.Note● When setting an IP address manually, ask the networkadministrator or your internet service provider whichIP address to use. If the IP address is set wrong, thenetwork may go down or Internet access may be disabled.● To configure the Scan to Local PC function via the WSDScan connection, follow these instructions.- Conform the IP version of the machine to that of yourcomputer.- Set [TCP/IP] setting to [Enable] on your machine.(By factory default, it is set to [Enable].)- Set [WSD Scan] setting to [Enable] on yourmachine. (By factory default, it is [Enable]. If ithas been disabled, enable it by referring to theConfiguration Guide > “Configuring the scanningto Local and Remote PCs” > “Using Functions forScanning to Local and Remote PCs” > “Enabling theWSD Scan”.)