Oki MICROLINE 520 User Manual

Also see for Microline 520: User guide Product update Guía del usuario Manual do utilizador Service handbook

Contents

Oki MICROLINE 520 User Manual Manual pdf 20 page image

Getting Started E-13Run the Self TestsAfter you've installed ribbon and paper, you are ready torun the self tests. Do this any time you want to make surethe printer is functioning properly.For wide carriage Model 521, be sure you havewide paper loaded!Font Sample Test Rolling ASCII TestTo run the test: To run the test:Turn the printer Turn the printeroff, then press off, then pressand hold the LF and hold thekey while QUIET key whileturning the turning theprinter back on. printer back on.To stop the test before it To stop the test:finishes:Press SEL. Press SEL.Selecting an EmulationYour printer has three emulations:• IBM Proprinter III (factory default)• Epson FX• Okidata Microline StandardChanging EmulationsYour printer is set at the factory for the IBM Proprinter IIIemulation. To change the emulation:1. Enter the Menu mode by holding the SHIFT buttonwhile pressing the SEL button. The following line willprint:Printer Control Emulation Mode IBM PPR2. Press the SET button until the emulation you wish toselect prints.3. Exit the Menu and save your setting by holding theSHIFT button while pressing the SEL button.!LFMicro FeedDownGROUPQUIETTOFSELSELEXITMENUSELSELEXITMENU