|User’s Guide: English 59Expanded Printhead GapYour printer can be used for dedicated bottom-feed printingon extra-thick multi-part forms. Extra-thick multi-part formsrange from 0.017-inch (0.43 mm) to a maximum of 0.03 inch(0.79 mm). To print on extra-thick multi-part forms, youengage the expanded printhead gap feature. This expands thehead gap settings for extra-thick forms and heavy card stock.It also increases the impact strength of the pins in theprinthead.! CAUTION! Once the expanded printhead gap isengaged, you cannot print on single sheets withoutchanging the gap back. If you try to print on singlesheets without adjusting the printhead gap, you candamage the printhead and void your warranty.To disengage the expanded printhead gap, reverse thefollowing steps.To engage the expanded printhead gap:1 Turn the printer off.2 Remove the access cover and the pull-up roller assembly.32T-02.eps and 32T-04UP.epsQUIETPARKTEARFF/LOADLFSELSELPOWER ALARM MENUGROUPEXIT ITEM SET PRINTMENU SHIFTTOFMicro FeedUpMicro FeedDownPRINT QUALITYCHARACTER PITCHHSDNLQUTLSSD10 12 1517 20 PROP3 Move the printhead to the center of the platen.4 Remove the ribbon cartridge.32T-19_up.eps
