78 Microline 320/321 Turbo/n|Explanations of Menu ItemsRefer to “Using Your Printer, Menu Mode, Menu Settings Table” for an overview of the menu structure.7 or 8 Bits Data Word (ML). If your computer system usesseven bits to make up each unit of data, change this setting to 7.7 or 8 Bit Graphics (ML). Choose the graphics your systemuses: 7 or 8 dots in each column printed.Auto CR (IBM). If you want the printer to automatically adda carriage return when a Line Feed is received at the end of aline, change the setting to Yes.Auto LF. If your printout is consistently double spaced,select No; if it overprints, select Yes.Auto Feed XT (Epson). If your system uses pin 14 of theparallel interface to control automatic line feed, change thesetting to Valid.Auto Select. If you always use the same Top of Form position,change the setting to Yes.Bi-Direction. Leave this set to Enable to allow the printer tocommunicate with the network.Bottom Margin. Change to Invalid if you want the printer toignore the bottom margin setting. Caution!! This can causeloss of data and damage the printhead.Centering Position. Used to limit printhead travel whenprinting narrow columns.Select Mode 1 for the narrow carriage printer.Select Mode 1 or Mode 2 for the wide carriage printer.Character Set. IBM or Epson: Choose Set I or Set II.Microline: Choose Standard, Line Graphics, or BlockGraphics.Code Page. Choose the Code Page character set you wish touse: USA (IBM 437), Canada French (IBM 863),Multilingual (IBM 850), Portugal (IBM 860), Norway (IBM865), BRASC II, Abicomp, Multilingual 858, or ISO 8859-15.Draft Mode. Change to SSD if you wish to use the SuperSpeed Draft mode of printing. Note: Print Mode must be setto DRAFT for this setting to be effective.Emulation Mode. Choose the printer emulation.
