42114101 Rev.1 58 /3214A4 21Figure 3-2 Figure 3-33.3.1 Printhead(1) Open the access over.(2) Pull up and rotate the head clamp 1 to unclamp the printhead 2 as shown Figure 3-2.(3) Disconnect the printhead 2 from PC connector 3.(4) To install, follow the removal steps in the reverse order.Notes on installation:(1) Insert the printhead 2 into the PC connector 3 while pushing it against the carriageframe 4.(2) The head clamp 1 must surely be sandwiched between printhead 2 and carriageframe 4 as shown Figure 3-3.(3) Be sure to check the gap between platen and printhead (see 4).(4) Be careful not to touch the print head while it is very hot.(5) Make sure that there is not any dust or oil on the connector contact section A. If itis found, wipe it off by alcohol.12
